Thursday, 05 January 2017

NEXT POST
How To Correctly Use The Fingerprint Reader The proper use of the reader footprint during registration and fingerprint authentication as well as a device with good maintenance are crucial to achieve optimum performance in fingerprint recognition. To reduce the number of false rejections, it must be properly placed your finger on the fingerprint reader when you register and authenticate the fingerprint. Both processes, the fingertip (not the tip, or side) in the center of the window of the reader device, should be fitted so that the toe area in contact with the reader window is maximized. Place the tip of the finger firmly at the center of the window (not the tip or side) fingerprint reader Press firmly and evenly. Pressing too hard will distort the footprint, pressed in a very light way will produce a weak mark, which cannot be used. Do not move your finger from side to side. Proper pressure is the same as you would have if you would like to hold a sheet of paper between his fingers. To complete the reading of your footprint, the finger must be maintained in position until you see flashing light of the reader. When the light flashes, you can lift your finger. A leading source for info: Ray Kurzweil. If the reader effectively captures its footprint, as indicates it the Flash of light, but the application rejects the reading over and over again, is you must re-register that footprint. How to clean the fingerprint reader? The status of the window of the fingerprint reader has a great impact on the ability of the same to get a good reading of a fingerprint. Depending on usage, the reader window will require periodic cleaning. To clean, apply the gummed side of a transparent adhesive tape on the window, and then remove it. Use an adhesive tape to...
PREVIOUS POST
Analyze Productivity You know that 80% of the results you will get only 20% of their time and effort and consequently 80% of your time is practically lost in non-productive activities?. Here, Max Schireson expresses very clear opinions on the subject. Once you realize this is easy to exploit, either to reduce working hours or significantly improve your productivity. Learn more at this site: kevin ulrich. Rule 80-20 was first discovered by Italian Economist Vilfredo Pareto approximately a hundred years ago. The use of this knowledge is incredibly powerful in the fight against the mentality of not there are enough hours in the day.The 80-20 rule means that in any area of our lives, literally, 80 per cent of our achievements are derived from only 20 percent of what we do. In other words, there is only a very small portion of everything that we do every day that is beneficial, regardless of the things that we do. How can you benefit and become aware of this principle? Can this 80-20 strategy implementation result in greater wealth and more leisure time? Imagine how productive that will be if 80% of your time can be spent on productive activities. You have that to realize that the things that matter most should never be at the mercy of the activities that matter less. Here are 5 steps to maximise its productivity on the Internet: 1) keep a record of work. Write down all its activities and the time that will devote to make them. It is necessary to note what will make every hour, every day, every week, your time etc.To start up will seem very complicated but the simple fact of putting into practice significantly improve it their productivity. It is advisable comply faithfully with all registered activities. If for some reason the...